A compressor has a lot of knobs and settings. They can be confusing at first. In this blog I am going to talk about one of those knobs – Threshold.
A compressor is an automatic volume control. We try to make the signal somewhat the same, static. Without a compressor, we would have to do it manually, turning the signal down, then up, then down, etc. But with a compressor, it can do that job for us.
When a signal gets loud (and crosses the threshold), it turns it down. If there’s any makeup gain, it will turn the softer signals up making them louder (along with everything else, of course). The threshold setting tells the compressor when to start working. Put a compressor on, say, a vocal track. Pay attention to the input signal on the compressor. Let’s say the input signal is -10 dB. Now set the threshold knob to -16 dB, and the Ratio 2:1. What we’re telling the compressor to do is this: Any signal that is stronger than -16 dB, I want it to compress (lower) the signal. When the signal crosses the threshold it will get cut (attenuated) in a 2 to 1 ratio. So in this scenario, the signal is coming in at -10, with the threshold set to -16 and a 2:1 ratio. This means 6 dB is going to get compressed in a 2:1 ratio. The signal will get cut down to 3 dB over. You can think 2 becomes 1, 4 becomes 2, 6 becomes 3, etc.
If the ratio was 10:1, the signal would get compressed more. The higher the number, the more the compression. If the signal crossed the threshold by 10 dB, then it would be reduced to 1 dB. The threshold determines how much of the signal the compressor is going to affect. You can change where the threshold is set usually in two ways. Using the Dyn3 compressor/limiter, grab the orange arrow on the signal led and slide up or down. Or to the far right at the bottom, grab the threshold knob and set up or down. TIP: If Pro Tools is your DAW, use the Dyn3 Compressor/Limiter (free). It helps to make understanding what and how a compressor works easier.
I hope this helps!
and HEY! Make it a great day!
Tim
Comentarios